DEX210 Wing - Where in stock?

[Origineelreclamebord]

When making the holes in the DEX210 wing I didn't measure and it turned out afterwards that the dimples on the wing were too far apart for fitting it onto the DEX210.

It will be a spare wing for my TRF201 as it does fit on that, but that means my DEX210 is now missing a rear wing. Is it in stock yet at a store based in Europe?

[mattybucks]

Get an LMR wing for it. Job done!

[mikeyscott]

Originally Posted by mattybucks

Get an LMR wing for it. Job done!

Yup much better wing, stock 210 wings are terrible.

Only downside to LMR - pig to cut..

[Adam Skelding]

Originally Posted by mikeyscott

Yup much better wing, stock 210 wings are terrible.

Only downside to LMR - pig to cut..

Terrible?
Justification?

Had mine on since the oOple race.

[mikeyscott]

Originally Posted by Adam Skelding

Terrible?
Justification?

Had mine on since the oOple race.

I may have just been unlucky but I landed badly and it tore off. No I hadn't drilled the holes too big.. First wing I have broken off in two years

Was going to put a 410 wing on, but picked up a wing from lee when he was at torch

[jimdaloo]

more importantly when are the wheels going to be in shops

[Origineelreclamebord]

Originally Posted by mattybucks

Get an LMR wing for it. Job done!

Originally Posted by mikeyscott

Yup much better wing, stock 210 wings are terrible.

Only downside to LMR - pig to cut..

The LMR wing seems like a nice, chunky wing, but I'd like to keep my DEX210 stock for now. As for cutting the LMR wing, a Dremel does the job, right? I always use a Dremel for my bodies, much more accurate if you don't try to cut through at warp speed

[Aran]

I have a LMR Electra wing on mine, fits okay just a little thicker than normal wing so the plastic washers won't fit. I have mine with washers underneath though.