cat SX3 spares. What parts should I carry

[axeman]

Please if anyone could advise what you need to carry as a minimum for the sx3 that would be great...

[FARLEY]

Steve the only breakages i have had with the sx3 is a mid belt, front shock shaft and suspension block holders , seems pretty strong have not replaced a wishbone our hub carries yet .

I would always have the above spares in pitbox .

hope this helps

Spencer

[axeman]

Originally Posted by FARLEY

Steve the only breakages i have had with the sx3 is a mid belt, front shock shaft and suspension block holders , seems pretty strong have not replaced a wishbone our hub carries yet .

I would always have the above spares in pitbox .

hope this helps

Spencer

what is the part number for the front suspension block holders?? I have looked on exploded diagram but unsure which part you mean.

Cheers fella

[leeboy44]

U3556
U3129
U3130 these 3 are a must as the plastic 1s snap looking at them

U3339, get these because the bearing spin in the plastic 1's and then come out the side of them

get a FAB to adjust the braking on the front

1 set of wishbones all round, i never broke 1 but there is always the first

front hinge pins U3306

rear hinge pins U3307 also the screws fall out of them

U3668
U3669 front and rear shock shafts ( i used losi 22 )

this is about it mate

i really give mine a hiding and it was fine

hope this helps

[leeboy44]

PS they do a hinge pin alloy holder kit for the rear 2 and the front but i cant find them on there website, also the FAB is not there

[Getpip]

Originally Posted by leeboy44

U3668
U3669 front and rear shock shafts ( i used losi 22 )

Are these the same size as the SX shafts (length)?

[leeboy44]

im surer there about 3mm longer mate

dave jackson will correct me if im wrong

[axeman]

Originally Posted by leeboy44

U3556
U3129
U3130 these 3 are a must as the plastic 1s snap looking at them

r these what spencer is talking about.