RB5 SP2 VEGA SETUP

[reg]

Hi,as the car has been out for a while could someone let me know a good starting point,a good all round setup,would the std sp2 setup that comes with the rear kit be ok to get used to the car,
thanks
Mark

[spenner]

http://www.petitrc.com/setup/teamxtr...VegaElite.html

Take your pick....

[reg]

Hi spenner,i found this one of yours from a while back,how did you find this one were are you at now

Front
32.5wt Oil (losi)
Piston 2c
Orange spring #55
Shock mounted outside hole on wishbone
Middle on Tower
Short Track (Washer on the inside of front axles)
Inner link position - middle with 2 washers
Outer link - long
Pivot block spacers - None
Kick up - 25 degree


Rear
27.5wt oil (Losi)
Piston 3a
Blue Spring #68
New Inside hole on wishbone (drilled one hole in from original postion)
Outside hole on revised tower.
Wheelbase - long in the dry, short in wet or when track is loose.
Camber link inner - lower, outer hole (short)
Camber link hub - Inner (short)
1 Degree Alloy hubs, 2mm washer under ballstud.
Roll bar - none

Tyres - Dry: Schu Staggers front, Yellow mini spikes rear
Wet: Schu Green Minis, Ballistic Buggy Green Spikes
Inserts - Answer RC Medium all round

Rudebits under speedo weight - 92g
If track is bumpy i add the Rudebits under lipo 72g
Wing - Vega low profile
Vega steering link

[spenner]

For a general setup that will be good for you... I still use that on 95% of the tracks i race on.

[reg]

Originally Posted by spenner

For a general setup that will be good for you... I still use that on 95% of the tracks i race on.

thanks

[reg]

Hi, was just wondering what the std rear toe is with running the plastic hingpin holders that come with the sp2 kit,iv got the one that says rf2 on it,what is the std anti squat iv got no shims under the hingepin holders,there also seems to be not much droop on the rear,do you run different shock bottoms,id usualy just undo the the shock shaft but there isnt alot to play with to keep it strong,also on the vega kit,in the bag with the motor mount the are 2 plastic shims,what are they for,thanks