York Indoor Regional

[Northy]

We have a meeting last night to sort this out.

One thing that people need to be aware of:

We will not be allowing people to have large open holes in thier shells that either:

a) allow a fan to protrude outside of the shell

or

b) allow a marshalls finger to go inside the shell and get caught on a fan.


I have noticed (while marshalling - ouch! ) that this is becoming more and more common. If this applys to your car then please fix it before York Regional, we will have a scrutineer at all times on race day that WILL fail your car.

This is a BRCA rule.

Thanks,

Graham

Now get your entries in!

[josh_smaxx]

What about holes that do not have a fan protruding/inside of them? Just mine has a big hole in the side but there isnt a fan on any more.

Also, any chance fo a post code?

[Chrislong]

Originally Posted by josh_smaxx

What about holes that do not have a fan protruding/inside of them? Just mine has a big hole in the side but there isnt a fan on any more.

Also, any chance fo a post code?

Technically, the holes you make in the shell should only be made where the moulding is marked to be cut. This is an Efra rule, not sure if it is a BRCA rule.

I think G is more concerned about safety, than penalising someone for having a hole which causes no harm.

[josh_smaxx]

Ye, i'll put tape round the rim so it isnt sharp

[Col]

Bring the tape with you, so the hole can be covered (just in case...)

[josh_smaxx]

will do