|
|
#1
|
||||
|
||||
![]()
Hey guys
OK ive been out for a long time and so much has moved on. I need a good charger, but dont want to break the bank too much! Looking at spending around the £70 mark on something that may charge, discharge and maybe balance? Id seen a 601BC unit on ebay and wondered if this would be any good? Its a lot different to the Millenium i used to have though. If not, can anyone point me in the right direction, id like something AC/DC if poss. Also, cells, what a safe bet to buy for racing nowadays, ive read the poss rule changes but i could do with a few packs to get me rolling, so 3700's maybe? lee |
#2
|
||||
|
||||
![]()
Just to clear up, the chargers ive looked at are by Imax, just wondered if anybody uses them, or if there cheap junk lol.
lee |
#3
|
||||
|
||||
![]()
So, nobody looking at this post uses a charger or can recommend one in my budget?
lee |
#4
|
||||
|
||||
![]()
I've been using the Pro-Peak Sigma AC/DC charger for about 7 months now.
It's not one of those large yellow faced jobbies, it's a slime line Blue / fake carbon fibre case with a digital readout, will charge and discharge Ni-Mh, NiCad, Lead Acid and Lipo batteries. I believe it has a balancing connection for Lipos although the required cable is not included. There's very little you can edit for the charge / discharge profiles but if you're not intending to look after any of the newer Hi-Spec cells then it's worked fine for me with older GP33000s and GP3700's so far. I think it was about £75 new. No doubt others will have other opinions but it's a start.... |
#5
|
||||
|
||||
![]()
I got a Pulsar 3 (new) on Ebay for about £75. From RC Mart (Dinbal) I think it was.
|
#6
|
||||
|
||||
![]()
I am using a Orion Advantage carbon edition charger and i ahve to say this is one onf the best charger you could get on the market
here is the link: http://www.teamorion.com/Products/Ch...+_+Dischargers |
![]() |
Thread Tools | |
Display Modes | |
|
|