|
|
#1
|
|||
|
|||
![]()
As title im building my 22 and have just tried my lipo and its too tight a fit and wont slide all the way back any ideas alsois it just me or are the hex head screws really soft rounded off a few
![]() |
#2
|
||||
|
||||
![]()
Are you using saddles ? Screw heads are fine, just make sure the tip on your driver is good
![]()
__________________
Stevie Brew [email protected] http://www.oople.com/forums/showthre...hlight=stegger |
#3
|
|||
|
|||
![]()
its a hard case stick
|
#4
|
||||
|
||||
![]()
Not gonna fit, needs saddles or a stubby losi lipo.
__________________
Team Schumacher www.racing-cars.com Paint by www.customblitz.co.uk Feedback http://www.oople.com/forums/showthread.php?t=67178 |
#5
|
|||
|
|||
![]()
oh i thought you only needed stubby if running mid motor this is getting expensive lol new batt needed then.
|
#6
|
||||
|
||||
![]()
A stick pack should fit just fine in a rear motored car, which one are you using? is it super large?
__________________
Model Junction, Boughton Raceway. |
#7
|
||||
|
||||
![]()
Have put a stick lipo in my son's 22 in mid set up.
With lrp sphere and original shell. Made an ally plate with 4 mounting posts.the two at the front are a bit longer just so the lipo clears the low profile servo. So please people no more moaning about no room for electrics,it can be done with a little bit of thought. bens losi 22 001.jpg bens losi 22 002.jpg bens losi 22 003.jpg
__________________
Corally SBX410 Associated B6d Tamiya M05 Tamiya M06 low rider pumpkin TLR 1.0,3.0 scte Yeldnips racing products Xfactoryuk Dms racing Corally uk |
![]() |
Thread Tools | |
Display Modes | |
|
|