|
||
|
 |
|
||||||||||||||||||
|
|
|
#1
19-03-2011
|
|||
|
|||
Help me!
I have recently installed a novak havoc bruchless system into my car, but there has been a few problems. Once installed after about ten minutes of steady running it, the plastic spur gear attached to the motor has worn down. The gear had no wearings before so must be the motor. This is unbelievable. Is there a metal hop up as i dont want to be changing the gear every ten minutes! help please write back asap
|
|
#2
19-03-2011
|
||||
|
||||
|
no motor will kill a spur only 2-3 things will do that, bad meshing between spur and pinion most likely case to loose,and or dirt getting into ether of them
__________________
Mattys the driver,my names carl
|
|
#3
19-03-2011
|
||||
|
||||
|
Have you checked the bearings that support the slipper shaft, you could have one missing or one that has failed.
What model is it? James.
|
|
#4
19-03-2011
|
||||
|
||||
|
Quote:
|
|
#7
19-03-2011
|
||||
|
||||
|
Just because it is brand new doesn't mean you can't get a dodgy bearing in the kit, it does happen. Have you checked that the mesh between the spur gear and the pinion isn't too tight? Also have you used the correct pitch pinion for the spur gear?
Like Bigred said aswell, is there any dirt getting into the gears?
|
|
#8
19-03-2011
|
|||
|
|||
|
its a schumacher cat sx 2 pro
and ok fair enough also it should have been fine as i took it to a shop so that i could get it done properly and i had a losi motor and that was dosgy so he got the credit back for that and fitted me this one. He is a dealer so i persume that he will know what he is doing
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Schumacher
Hybrid Mode
