Lipo charger over voltage error message?

[Speeed Freak:)]

What's going on? Is my lipo dead?

Lipo still about half charged after 1 heat, gone to recharge and get this error message?

All other lipos charge ok so guessing charger ok?

Plug lipo back in to car and runs sweet still?

Any ideas?

Charger error outs on all modes!

Using a Icharger 106b

Also tried it on an older charger I have and that too errors out!

Lipo is a trekpower gold 4900

Thanks for any help
Andy

[leeleefocus]

Have you tried charging without balancing

[Speeed Freak:)]

Originally Posted by leeleefocus

Have you tried charging without balancing

Yep! Tried all settings! Just errors out!

[CrashBangWallop]

Try discharging the lipo until usual cut off then try recharging from discharged state in unbalanced mode.

At the very least if your lipo will not recharge then it is in a 'safer' state for disposal.

[leeleefocus]

Check the pack and cell voltages and then post back up with results.

[Speeed Freak:)]

Originally Posted by leeleefocus

Check the pack and cell voltages and then post back up with results.

Charger errors out so can't even see that?

[Speeed Freak:)]

Originally Posted by CrashBangWallop

Try discharging the lipo until usual cut off then try recharging from discharged state in unbalanced mode.

At the very least if your lipo will not recharge then it is in a 'safer' state for disposal.

Will run it down laters and see what happens!