Does anyone know?

[gordy]

Just wondered if anyone knew how many of the new B44 parts will fit on the BJ4 WE? As I imagine in the UK it'll be alot easier to get B44 parts.
Cheers
Gordy

[Andy Moore]

Originally Posted by gordy

Just wondered if anyone knew how many of the new B44 parts will fit on the BJ4 WE? As I imagine in the UK it'll be alot easier to get B44 parts.
Cheers
Gordy

The rear hubs, casterblocks, and steering blocks all fit, as I have them on my car.

[andy05]

Andy have you tryed/fitted the b44 slipper unit?

[Andy Moore]

Originally Posted by andy05

Andy have you tryed/fitted the b44 slipper unit?

The problem with that is front drive shaft dog bone, the AE unit is a CVA and the JConcepts part is from MIP, so I doubt they'll mate up. Perhaps if you have the appropriate lenght dog bone, then it may work?

[Deception]

couldnt you just put the AE bone in the Front and Rear Center while using the B44 slipper? i would think it would work all you woud have to do is get the bones.....

[Andy Moore]

Originally Posted by Deception

couldnt you just put the AE bone in the Front and Rear Center while using the B44 slipper? i would think it would work all you woud have to do is get the bones.....

I doubt the AE CVA bone would work with the MIP CVD axle/shaft. I dont think you can use the entire front assembly (CVA, gear, bearings, etc) because the bearing spacing on the tranny cases is different.

From what Ive heard, the "new" slipper is barely used anyway, its just there to save the diffs when landing under hard acceleration.