Pinions

[sldmodels]

I think my problem with the shark for a long time has been gearing, so after a long time trying to figure things out (and I am a very slow learner), I've ordered myself a 9 or 10 tooth pinion from RW (should hopefully have it and a newish speedo to have a setup and possibly a run at hereford on friday).

Silly question maybe, but just need something confirming. If I can't get a pinion small enough to stop my motor and speedo burning out, do I get a bigger or smaller spur gear?

(I have been offerend the lend of a 10 tooth pinion (thanks), but I want to get some testing doing before turning upto another national and going home with a dead car after practice).

[Jamie.T]

What motor you using, and also what wheels/tyres? Also what kind of track e.g, fast, slow, high grip e.t.c?

[sldmodels]

The last motor I used was a lose excelleron I think, blue thing that I got from someon on oople. I'm now using a Noram 7t with a 2.3mm shaft which is causing so many problems getting a pinion the right size. I think the pinion I was using was just too big, something like 13 or 14, and I'm going off what other people have wrote about motors getting hot running 10 and 11 tooth pinions, and I don't want to burn out any more electrics.

The car is the shark, and I'll be running at Hereford and Ardent (hopefully gonna go practice at Ardent the Saturday before the next off road meet). Wheels and tyres, white / yellow rally blocks.

[rondoolaa]

i start at 10/49 and if i lower the spur by 4 then i higher the pinion by 4 etc

[sldmodels]

Think my car must be running a 45 tooth spur, as the 10 tooth comes no where near it. Have order two 49tooth spurs so should have them in time to fit, test and race next weekend.

[rondoolaa]

13/45 should be spot on just in case you dont wanna fit your 49 yet,

put it this way, the guy that gets the most laps and best times at our track runs 13/45, and when i say his car is fast its an understatement

[Dombrasky]

Bigger