Shock pre-load on setup sheets

[Big G]

What is this?

[fmo]

As far as I understood it should be this...

[Big G]

hrmmm. That's what I thought, but when I set my shocks up to this based on someone's setup sheet I got next to nothing in ride height. No where near the 22mm listed. I had to put like 25mm of gap to get my ride height up. using the same springs also just in case you wondered

Unless this one setup sheet I was using had an error and it should of been 26mm in stead of 6mm. could be

Scrap that. Just checked the other sheets and the most they list is 9mm, but still a ride height of 20mm

[maky]

I have to run a lot of preload on mine . 4 durangos at our club and all run different amount of preload

[Big G]

so the pre-load is the gap between the collar and the top of the shock then

[Chris Doughty]

I would just set your car to match ride height, don't worry so much about pre-load on the shocks