More Problems !

[gargreen7]

the motor will only reverse! if i hit forward i don't get anything not even a whine. couldn't think what this could be or how to over come it. any ideas ?

[mark christopher]

ur going to have to give more info

tx throttle chanel reversed
motor wired wrong

[gargreen7]

everything is on the same settings it has been, the only reverse is the servo, which works fine. the diff has currently been apart to fit new bearings but worked fine right after .

[Battle_axe]

Turn the car off and unplug then turn it on push full throttle then full break it should then be fine I take it your using the kit esc?

[metalmickey0]

You might have to reset your settings and setup the system again. Had to do the very same thing on my B4, and all i did was take motor and esc straight from SC10 and install in B4. Did nothing else but unplug and plug back in once in new car.

[gargreen7]

I've tried doing the reset but didn't seem to work, I'll try it again when I get home though.

To clarify, unplug the car. Turn on the radio, full throttle then full brake, re plug the car and try to see if it works ?