|
|
#1
|
||||
|
||||
![]()
Hi Guys,
Just built my RB5 SP2 goes together so well ![]() But i realised about the flanged metal spacers, has anyone replaced these for bearing ones instead? I'm right in saying the actual size required is 3x6x2.5mm? When i start on the FS2 i can change them to the bearings cause they will feel alot better
__________________
http://www.pbmracing.co.uk/ Kyosho MP9 TKI2 Team Orion CRF US edition & Team Orion CRF Alpha 5port Kyosho ZX-5 FS2 Kyosho RB5 SP2 LRP SXX TC & Brushless X12 Speed Passion |
#2
|
||||
|
||||
![]()
Yeah i added the flanged bearings, not sure on the size though.. they are the same for the FS
![]() When i put them on both cars they took out alot of slop! ![]() |
#3
|
||||
|
||||
![]()
nick where in the fs are you putting these bearings pal???
|
#4
|
||||
|
||||
![]()
It's in the steering
__________________
http://www.pbmracing.co.uk/ Kyosho MP9 TKI2 Team Orion CRF US edition & Team Orion CRF Alpha 5port Kyosho ZX-5 FS2 Kyosho RB5 SP2 LRP SXX TC & Brushless X12 Speed Passion |
#5
|
||||
|
||||
![]()
As Rob says, on the ackermann bar.... the bit that sits underneath the forward center shaft your steering turnbuckles then attach to it.
Cheers Nick ![]() |
#6
|
||||
|
||||
![]()
The size stated is spot on ... they come as standard in the RCBearings ZX5 / RB5 packs as I speced them
![]() Kyosho obviously do them too. |
![]() |
Thread Tools | |
Display Modes | |
|
|