losi xcelorin problem

[Fila1223]

Hi I just install losi xcelorin 4,5 combo on my xxx cr and when I turning on i cant do anything motor starts turning at full speed I cant stop it I can only turn my servo please halp mee i dont known why it just happens

[Huckster522]

I think this should be in the electrics thread to start with.

Have you tried setting the end points up to your transmitter using the setup button next to the power switch as per the instruction manual?

that may help.

[Nige]

Had the same problem when I installed mine - look at page 14 or there abouts. You need to calibrate the esc with the receiver. If I remember correctly, turn on transmitter, then turn on esc whilst holding the small button next to the switch......

Whoever wrote the instructions was a berk Why didn't they just put it on page 1!!!

[Fila1223]

thanks for help but it doesn,t work when I put swich on in the esc the blue yellow and red leds starts light on the same time

[Nige]

Just found my instructions:

1) Turn on the transmitter
2) While turning on the vehicle Press and Hold the setup button, notice the Yellow LED is now ON solid. Whe the Yellow LED is on solid, you can release the setup button.

Sounds like you've already tried this, so sorry can't help as not sure what's wrong.

[Fila1223]

I calibrate him but for some reson he goes on full speed and i can't control that maby it was software problem