|
||
|
 |
|
||||||||||||||||||
|
|
|
#1
02-08-2010
|
||||
|
||||
new Procat sideplates?
I'm looking at getting some new Procat sideplates laser cut out of 1.5mm stainless steel. I'll end up with quite a few spares so I wanted to guage interest and find out who would also want some. The cost per pair might be about £13 plus postage depending on quantities. Please PM or email me.
These are the templates I'm working from. Do these also fit previous Cats? 
|
|
#2
02-08-2010
|
||||
|
||||
|
The XLS had the same side plates - would be surprised if the SWB didn't.
I'd be interested in a set... will PM.
|
|
#3
07-08-2010
|
||||
|
||||
|
I wonder does anyone know what the recommended pilot hole diameter is for these little No.2 self-tapping screws? I can measure off the plates I've got but I was curious what is recommended for aluminium? Is there a chart online somewhere?
|
|
#4
14-08-2010
|
||||
|
||||
|
I'll be going to the sheet metal co. on Monday. Luckily they've got one of the stronger aluminium alloys in stock. The plates will be left natural like the kit items. I'm getting all the details sorted so they'll be perfect. Price looks like £13 a set plus postage. Please let me know if you want a set as I'll only do one batch. Luke
|
|
#5
14-08-2010
|
||||
|
||||
|
Two sets for me please!
|
|
#6
16-08-2010
|
||||
|
||||
|
Update: got the drawings from Fibre-Lyte! The metal fab. co. are sending me a sample of the material so I can check out the finish and try the self tap screws before we go ahead. THE PLATES WILL HAVE BOTH HOLES AT THE REAR SO THEY WILL FIT THE SWB AS WELL AS THE XLS AND PROCAT.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
