25mm lipo

[BostonNelson]

Hi all.

If you want to use 25mm lipos in the DEX410 do you only need the new battery holder set or do you also need the new motor mount plate?

Anyone tried yet?

[Adam Skelding]

Hi.
You need the motor mount plate and the slipper mount (battery side) from the 'R'. You'll also need the battery strap and rear drive-shaft angle brace. We'll be doing a walkthrough for existing 410 owners on what you need and 'how to'.

There will also be an optional Alloy slipper mount.

Keep your eyes on the tips and tricks section of the blog.

[BostonNelson]

Sweet! Fast car and fast answer.

[fastinfastout]

you dont have to buy any new parts.

just raise everything up 1-2mm, bit of dremeling!

[BostonNelson]

Well I'm afraid I'll do some irreversible damage if i try raising everything myself and I don't mind byuing stuff

Would be nice to see some pics if anyone done it on their own though.

Originally Posted by fastinfastout

you dont have to buy any new parts.

just raise everything up 1-2mm, bit of dremeling!

[kriske]

To fit 25mm lipos to the current DEX410 you need the following;-

New parts:-

TD310155 MID DRIVE GEAR PLATE (ALUMINIUM) (25MM)
TD310156 MOTOR MOUNT PLATE (25mm)

Revised parts:-

TD310039 GEAR BOX SET: FRONT & REAR
TD310005 BATTERY HOLDER SET (LIPO)

The new motor plate and mid drive gear plate raise the slipper assembly and the new gearbox sets angle the diffs a little more to raise the driveshafts at the diff end. The new battery holder set has a couple of shims to raise the mount at the clip end.

I hope this answers your question