Slipper clutch burnt out! Why?!

[heinzeman]

Hi all.

My CAT sX made a bad sound on short grass the other day. On inspection, removed the spur gear, and found that the hole in the centre of the spur that mounts on the layshaft had melted, which allowed the spur to move about so it was not spinning true.

It was the standard 83T. I have now replaced it with an 82T. I have kept my pinion the same, which is a 22T.

Does anyone know what caused this melting and what I can do to prevent it happening again?

I had tightened the locknut on the end of the layshaft as per the manual I.e flush with the end of the layshaft.

Please help!!!

[mikeyscott]

Running the slipper too loose

[Cruise]

You need to compress the slippers pring once completely as this will settle the spring.And you should use threadlock on the slipper nut to prevent against loosening.

Cruise

[heinzeman]

Originally Posted by Cruise

You need to compress the slippers pring once completely as this will settle the spring.And you should use threadlock on the slipper nut to prevent against loosening.

Cruise

oh, I was hoping it would be something that simple! I will compress the spring and then loosen it as suggested.

After that, any recommendations as to how much I should tighten the locknut? At the moment I run it flush with the end of the layshaft.

thanks guys

[ant west 71]

hi, while holding the rear wheels, you should just about be able to turn the spur gear. if you cant turn it then its to tight, if it turns to easy then tighten more. mine is set with around 2mm of thread showing. hope that helps

[ant west 71]

hi, while holding the rear wheels, you should just about be able to turn the spur gear. if you cant turn it then its to tight, if it turns to easy then tighten more. mine is set with around 2mm of thread showing. hope that helps

[bigred5765]

Originally Posted by heinzeman

Hi all.

My CAT sX made a bad sound on short grass the other day. On inspection, removed the spur gear, and found that the hole in the centre of the spur that mounts on the layshaft had melted, which allowed the spur to move about so it was not spinning true.

It was the standard 83T. I have now replaced it with an 82T. I have kept my pinion the same, which is a 22T.

Does anyone know what caused this melting and what I can do to prevent it happening again?

I had tightened the locknut on the end of the layshaft as per the manual I.e flush with the end of the layshaft.

Please help!!!

most likely its been set to loose, this makes them very hot and melts/softens the plastic, set it so it just slips for a second or two from a standing start,on high bite track

[heinzeman]

Thanks guys, that's really helped me out. Always learning new tricks!!

[stefke]

The SX "white" spur doesn't tolerate a loose slipper. The SX2 (or Cougar SV) black spur gear is a lot better in this regard.

[stegger]

Or if you prefair the Losi or Associated spur gears i know somebody who does modified layshafts

[mikeyscott]

Or RW Spurs gears for no modifications which can be purchased from MK Racing

78 - 83 range