Heatshrink

[Hog]

Didn't put this in the electrics section as it's more a general enquiry.

Anyone know where I can get heatshrink big enough to go round a 4 cell Nimh pack in [][][][] configuration?

Not been able to find anything large enough so far - I run them this way so I can still put them on an LRP tray hence needing the bigger heatshrink.

Thanks in advance for any help.

[MiCk B.]

Hey,

2 cell heat shrink should do.

http://www.cmldistribution.co.uk/cml...tId=0000000211



That's what I used to use for saddle packs for 4wd.

MiCk B. :-)

[Hog]

Cheers Mick - will that fit round 4 cells though (widthways)?

[MiCk B.]

The twin cell shrink with fit cells built like this:



MiCk B. :-)

[Hog]

Okay - thanks. My original post does say it's for 4 cell packs though. And that it needs to slide over the cells the other way round so the terminals are still exposed to fit on an equaliser tray.

[MiCk B.]

Ah..... I think I understand now more what mean.

Don't think you'll get heat shrink big enough for what you want.
But what you could do is, shrink the packs as per the photo, 4 cells.
Then cut away the heat shrink, where it covers the connecting bar between each cell, this would then allow the equaliser to make a connection, as well as the heat shrink holding the packs together.

MiCk B. :-)