Help with build!

[Chris Griffiths]

Hi guys, as im new to all this im totally lost with some things.

THIS QUESTION IS SORTED!!!

[Chris Griffiths]

Also how do the hangers fit? do i need to fit smaller turnbuckles? looks like i do to me but would rather have this confirmed.

Also theres longer turnbuckles and a medium length pair do these go at front? if so which way around.


Thanks

[Chris Griffiths]

another problem is when my wheels are level my drive shafts jusy about go in my outrives?

[Darren Boyle]

Originally Posted by Chris Griffiths

another problem is when my wheels are level my drive shafts jusy about go in my outrives?

Have you fitted the X-Factory axles from the kit? Did you install the supplied spacers in the coreect place (these go over the axles first - then the axles goes through the hub bearings - ie they are on the inside)

This is probably what you trouble is........

[mark christopher]

chris

E speed hangers bolt where kit ball studs should be, ball high is where most run em, yes you need shorter links.
Is your gear box in low posistion? You may need the longer axles, but thats normally on full droop.

[Chris Griffiths]

Cheers for help! yes id put spacers on outside thanks!

Also gearbox is low as set up sheet in the ellis kit

Im using all the turnbuckles that come with the ellis kit aswell as the ends that are longer than ae ones.


Cheers ill give that a go!


Chris

[Chris Griffiths]

More problem!

when I put servo forward it hits the servo saver when wheels are straight, would you dremmel the servo saver down?

using a savox

Chris

[Darren Boyle]

Originally Posted by Chris Griffiths

Also how do the hangers fit? do i need to fit smaller turnbuckles? looks like i do to me but would rather have this confirmed.

Also theres longer turnbuckles and a medium length pair do these go at front? if so which way around.


Thanks

Chris, depending on which ballcups you settle on, yes you will need to use the shorter trunbuckles ion the rear with E-Speed hangers