Not a buggy - P4M

[Garry]

P4M, aka, a Pro 4 Mini.

Sorry for the blurryness, it was about to rain and it finally did when I snapped the last one.






Its built out of a pile of spares I have from a Pro 4 and a Cyclone.

The body is the old beater from an Ebay M03 - the wheelbase is right but the width is out and the front arches needed enlarging.

It still takes 6 cells, and the front gearbox design means it can be swapped from a spool, or a diff to a oneway when needed. Front wheel drive, but if I can get the centreshaft cut down, it can be 4wd too.

Haven't run it yet though. Any Q's, just ask.

[Garry]

More pics:







Just a few more jobs to do before its ran, such as countersinking the bottom rear of the chassis, and getting some longer front shock tower screws and spacers.

[losidan]

hi mate,

like your car...Just a thought...would something like a Kamtec shell be any help. the ones for the ministock are 178mm width or the ones for he v12 are a bit larger and may well accomodate

[schmacher]

garry, i also made a 1/12 scale pro 4...i'll post some pics tomorrow...i have the same problem trying to find a body to fit too

[xx4-nutter]

i like the idea of the servo at the front like that, good idea

Garry D.

[schmacher]

here are the pics of my mini pro 4