XXX-4 Front driveshaft options

[jimmiprice]

Guys ive just bought a new Losi XXX-4 G+which i thought was supposed to come with MIP CVD's. The box says it does and so does all Losi literature. However mine came with the usual big plastic driveshafts the old XX4's and XX's used to come with in the rear which i dont mind as they are pretty bulletproof. In the front came some bizarre driveshafts ive never seen before which ive been told are LCD's and not that good. I took care in building them properly and even put some heat shrink tubing over the tube the pins go through which kept them together for 3 qualifying runs but in the final i lost front drive. After checking it seems the pins in the CVD part are still in their original central position and tight but the connecting tube is missing completely. I can only assume as the pins are still as they should be the tube has twisted or bent and came out never to be seen again. I know i can buy a rebuild kit which will give me the part i need to repair them but i would like something a little more bulletproof.
Im thinking that the X Factory X5 and XX4 will have the same front shafts so there must be some other options rather than these LCD's.
Anyone have any ideas or links as to where ill find them ??
Jimmi....

[blade]

hi, had the same problem got the rebuild kits but the same thing happened.I then got cvds from dms and have not looked back. The lcds have better steering so i put in one way diff in.

[Brodieman]

Check out MIP's newer axles for the XXX4 (front only). they have a pin capture ring. The pins on my cvd's are wrecking my dogbones so I am investing in some Hudy pins then filing a flat area in the middle so the grub screw has more contact with the pin. Anyone tried drilling new holes in the dogbones?? why don't they make them with multiple holes? actually i know the answer, you would not need to buy a new dogbone

[Ferret]

I drilled new holes in aluminum bones, so far so good.

Avner.

[Darren Boyle]

Originally Posted by Brodieman

Check out MIP's newer axles for the XXX4 (front only). they have a pin capture ring. The pins on my cvd's are wrecking my dogbones so I am investing in some Hudy pins then filing a flat area in the middle so the grub screw has more contact with the pin. Anyone tried drilling new holes in the dogbones?? why don't they make them with multiple holes? actually i know the answer, you would not need to buy a new dogbone

Hi the MIP C-CVD's are now here and available in the UK, however they only make a rear to fit the XX4/XXX4/X5 but NOT a front as you put in your post

[stampede vxlboy]

front and rears is it the drive shafts or the cvd shaft .whats the part numbers plz any prices

[super__dan]

Not the same no, both outer axle and dogbone are different.

I dind't know they came with LCD's now, that's not good as Brian Preddy aside most people can't get them to hold together as you say!

[Brodieman]

My bad
crap, going to have to baby my front cvd's. don't break little guys

Originally Posted by DMS Racing

Hi the MIP C-CVD's are now here and available in the UK, however they only make a rear to fit the XX4/XXX4/X5 but NOT a front as you put in your post