410 electric install?

[sime46]

Just finished my build and to be honest I'm scratching my head to figure out a neat install for my radio etc. Any tips from you guys or pics would be mint. Its tight as we all know but I'm unsure about where to put my servo wire and which way round to fit my speedo(sxx). Thanks guys. I just dont want to make a bollox of it. Cheers.

[telboy]

Hey Si, Well you saw mine at the weekend. Thats how Adam wired his too and his was SXX.
As for the servo wire. Mines pretty long (ooher!) So it went better, exiting from the receiver side, and going all the way round the back of the servo, to the motor side, and back in front of the servo to the receiver....if that makes sense. lol it created less 'bunched up' wires all in the same place.

You can always shorten it and take it directly to the receiver. The wire will fit rount the servo saver posts without it affecting the shell fitment.

I'm actually going to re-wire mine...again. Cos I got quite a bit of interference in the final. But its a case of suck it and see. If it fits then its good, if not then try again. lol
When I've re-wired mine I'll post some pickies.

[sime46]

Your a wonderfull man Tel. I'm on with it now. Wish me luck.

[Chupstar]

here is a pic off mine
Vampire Lipos
Lrp 7,5
Lrp SXX
Sanwa Dsss
and a Fut 9550 Servo

[carlin]

I have the same problem here keep scratchin my head thinking how the hell is this going to fit.

Servo wire greet but the way the wire goes it rubs slighty against servo saver.

This is what I'm trying to fit in the car

LRP SXX
KO Rec 301
Ko Servo Low Profile
LRP x12 6.5

I've done few attempts but looks so messy.

Any chance some of you guys got any close up pics of your wiring an it installed

[sime46]

Its done! Looks ok. More room than you think. Its tight but do-able. Gotta make sure nothing rubs the prop or spur. I need to extend the wires to the power cap so it will sit where I want it to. Its easier cos you can mock it up and take the speedo and motor out to solder. Much easier. I'm iking this car a lot! I expect I'll re-wire it 3 more times before I settle on my final install but so far its going well. Just need a shell now and were up and running.