just got a b44

[colin563]

ive just purchased a b44 used chassis from here

now i need advice

on a brushless combo for it

1 LRP Brushless A.I. and Eraser 10.5T Combo

2Losi 1/10 Xcelorin S 10.5T Brushless Combo

i want it for bashing on my back garden

have i made the right choice in size or do i need less turns for the motor

next what pinion and spur would i need for this

also were would i purchase these from

thanks in advance for any replies

colin

[rc_penguin]

Go for the losi combo, much better value plus sintered rotor, ive had the earlier automatic set up stuff from LRP and its terrible, i turned it on and the speedo got all confused with itself, then it went up in smoke and melted got a free replacement and it did the same thats personal experiences though not sure about the newer ones. have also had bad experiences with bonded rotors, so go for the losi set up! oh 10.5 turns should be plenty fast enough. Hope this helps

[colin563]

can anybody give any advice on pinion and spur sizes for this setup


thanks colin

[leightheiceman]

ive had a losi set 6.5t and it was ok, cheap... much more feel with the latest update, but had few problems and horizon hobbys sorted them.
now i run LRP tc shere (25y warranty) with a losi motor and its much better
.
i run a 19t pinon on standard spur

if you get a losi system dont install set up from the disk! go on there web site and install v2 of the set up program, then you want to update you ESP through the set up, too v2.8 then you shouldnt have any problems.

[colin563]

thanks for reply and info

weres the best place to buy pinions from also spares

as im going to be breaking a few bits

colin

[ashleyb4]

http://www.dms-racing.com/

Proberly the best model shop in the uk.

A