|
|
#1
|
|||
|
|||
![]()
Has anyone experienced their ball diff loosening? It did it with me straight out of the box. I've removed it and rebuilt it but the same thing happened! Any ideas or advice would be appreciated.
|
#2
|
||||
|
||||
![]()
have you bed it in...as they need tightening after first few runs
__________________
~Rick Evans~ ~LRP~shark st ft~lwb~ ~Carisma GT14B pro~ ~Schumacher KF2~ ~Schumacher Atom~ ~BSR Basher-RallyX~ ~Ascociated RC8.2e RallyX~ ~TeamC T8EV3 RallyX~ phat bodies worm-racing http://www.mendiprcraceway.co.uk |
#3
|
|||
|
|||
![]()
Ah no, think I missed that step. Thanks for the reply.
|
#4
|
||||
|
||||
![]()
I allways set mine too tight from a rebuild and they readjust, you are locking the grub screw onto the bolt after rebuild?
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#5
|
|||
|
|||
![]()
I'm sure I did lock it in after the rebuild. I think I'm going to rebuild it again just to make sure that's done, then I'll run it in and check it again.
|
#6
|
|||
|
|||
![]()
I've personally not had any issues and that's even without fully running it in.
Just make sure the locking grub screw is in place.
__________________
Ardgay Models Schumacher CORE-RC Hobbywing Mark One Designs |
![]() |
Thread Tools | |
Display Modes | |
|
|