About the larger belt roller?

[cabbynate]

I installed the larger belt roller and noticed it get's very close to the top belt after the fold. They don't make contact but a hard landing off power might make them touch no? Other wise it seems to roll more free.
Any input would help.
Thank's M8.

[Chrislong]

I haven't found any issue, ever, just how close is it?

What is the part number of the item you fitted? It should be LOSA3282 for the large roller alone, or LOSA3280 for the complete kit.

[cabbynate]

To be honest I'm not sure what the part # was as I just had it already attached to a Losi XXX4 or XXXS belt tightener It's got about as much room as the thickness of the X-5's belt tightener arm. Maybe a tad bit more. I will run the buggy today and report on how it went.........
Thanks for the reply Chris.

[Chrislong]

Where are you racing? Hope it goes well

[cabbynate]

Originally Posted by Chrislong

Where are you racing? Hope it goes well

Vegas Baby!!!!!!
Cutting Edge R/C raceway. Indoor, medium grip, 80x40. Fun place to race and only 20 minutes from home.

[super__dan]

You know there's nothing to stop you making a new hole in the tensioner bracket. I've done this before using a drill a few 1/10th mm smaller, then driving one of those Losi tapping screws through. I have/had (been that long since I've had it out) a twin pulley setup for more wrap with the stock pulleys. 2nd one was as high and far forward as possible to increasr wrap.

This black one sounds better though, so I have one on order and will try it.