Orca vx3 program card cable

[Tone]

Bought a mi4cxl and this came included with an orca rx3 motor I think.

Unfortunately the person has of course lost or not sent the cable for the program box.

Does anyone have an idea where I might acquire a cable and what one looks like?
Will any Lead 3 pin to 4 pin do the job?

[tomtom]

MB models should have some. It is a three wires receiver plug to a 4 wires plug similar to a sensor cable connector.

[beale]

Mine came with 1 but it doesn't work so I connect the receiver cable to the box like the older VXX and that works every time

[Tone]

Originally Posted by beale

Mine came with 1 but it doesn't work so I connect the receiver cable to the box like the older VXX and that works every time

Does that work without using the 4 pin slot?

[beale]

Sorry only just noticed your reply, the 4 pin slot doesn't work on mine so I just unplugged the receiver wire and put that in the box as you did on the VXX, the 4 pin was to make it easier if it works

[Tone]

Originally Posted by beale

Sorry only just noticed your reply, the 4 pin slot doesn't work on mine so I just unplugged the receiver wire and put that in the box as you did on the VXX, the 4 pin was to make it easier if it works

And that will keep your settings? I thought they were lost if you unplugged the receiver