|
|
#1
|
||||
|
||||
![]()
Yesterday I raced at Batley and noticed that though my car and driving was approximately on the pace in the windy stuff and the straight, there were a couple of parts of the track with jumps of differing size. I tried different lines and approach speeds but found that if I tried to jump at a reasonable speed I would either nose dive or cartwheel on landing. If I tried to take jumps steady I could get consistent lap times and stay on my wheels but ended up being approx. 3-5 seconds a lap off the faster chaps.
Are there any good tips for jumping? I know I hear about "plip the throttle" and "use the brakes" to "balance" the car in flight, but how does that work? The only thing I know is that if I open the throttle in flight then my car back flips rather than nose dives, so clearly there must be a happy medium? My car is a Yoke YZ-2 and drives like a dream when wheels on ground. I also can't blame the poor jumping on the car as it is clearly my driving, but just asking for help and advice ![]()
__________________
I've got Araldite and a Swiss Army Knife - what more do I need? Yokomo YZ-2 No 4WD because nothing lives up to my original Optima. Until now maybe?... |
#2
|
||||
|
||||
![]()
If the nose is dropping off the jump, then the rear of your chassis could be slapping the top of the up ramp causing the rear to kick up.
But basically practise on the mid air control, throttle brings nose up, brakes drops it down again |
#3
|
||||
|
||||
![]()
What kind of ballast and damping you running Chris? Have yo say, i put very little input on my YZ2, since running some weight that is, kit spec was awful and very rear heavy!
Lee
__________________
INSERT COIN
|
#4
|
||||
|
||||
![]()
Ok ive time for a better input! Last Friday i ran kit springs, 450wt front, 400wt rear!
20g at the servo front, 50g shorty weight, and rear brass hangers, which equates to an extra 18g, and im jumping flat and level, super neutral, larger jumps to kick the front up some, so i dab a brake to drop that in! Im running 10% drag too, which helps me TBH! Even running rear purple, i still get a nice level take off, i find it now more stable in the air than my XMW, which was pretty wicked on jumping! Lee
__________________
INSERT COIN
|
#5
|
||||
|
||||
![]()
It's all dependent on the type of jump to the way you approach it from my experience. Which ones are you struggling with at Batley?
Cheers Chris |
#6
|
||||
|
||||
![]()
I have got a brass weight up front and also in my bag I have the under shorty wt, but not used it yet (handling didn't feel like it was needed).
At Batley, the far left double with drop off seems to have caught me a few times - last time in the slight damp I had slightly more traction and seems to get a better line into it to jump flat. Yesterday, my car set up was same, but due to the dry sand on the approach bend I presume I had different speed at take off and I flipped out a few times, to the point where I was taking it much steadier simply to make sure I didn't lose time on my roof. I think similar was the case for each jump, because the layout varies each week I hadn't struggled before, but yesterday I just seemed to crash a lot so ended up slowing down due to lack of confidence on the jumps.
__________________
I've got Araldite and a Swiss Army Knife - what more do I need? Yokomo YZ-2 No 4WD because nothing lives up to my original Optima. Until now maybe?... |
#7
|
||||
|
||||
![]()
I was on standard springs and the brass weight under the lipo. Car felt very balanced and good. It was breezy yesterday which never helps.
|
#8
|
||||
|
||||
![]()
Hmm, think I may add the under lipo weight for next time and see how that feels. I'd been loathe to try it is car felt so good on ground. Will also try to have a practice at some point just doing the jumps. Need to learn the reactions to blip with a wheel Tx as that never feels as easy as with a stick
__________________
I've got Araldite and a Swiss Army Knife - what more do I need? Yokomo YZ-2 No 4WD because nothing lives up to my original Optima. Until now maybe?... |
![]() |
Thread Tools | |
Display Modes | |
|
|