battery charger

[dr durga]

hi guys does anyone have a new or secondhand carger which can also charge lipo? 60 pound max

[footey]

hi m8 ring mb models as mike sells chargers that will do both lipo and normal cells for less than that number in my sig

[dr durga]

hmm ok ill do tht tomoro... just found this i is ok? http://www.modelshopleeds.co.uk/cata...93bf01d0af9dfa

[i4n]

I (and a few others I know) use one of these:

http://www.actionmodelcentre.co.uk/p...od=JPD-4402900

I've used it with both Ni-Mh and LiPo and it is one of the best chargers I have used, I prefer to use it over my Much More CTX charger which cost about 3 times as much!

You'll need a power supply with it too if you haven't already got one - the one I use is http://www.modelsport.co.uk/?CallFun...n&ItemID=23410 but there are loads of others out there, just make sure it is powerful enough (better to pay a bit more now for a quality product then get a cheap one and have to buy the quality product in a few months time - I learnt this the hard way ). If you want to get both from the same place this charger is also good http://www.modelsport.co.uk/?CallFun...n&ItemID=29476, I've seen a Schumacher sponsored driver using it.

Ian

[bmx833]

if i would you i would get the imax b5 from modelsport, 62.29? ithink posted it was.
charges and balances all my batteries and never had any problems with it, great charger for the price
also i had that xbase before but it couldn't balanceand everyonce in a while it would false peak
just my 2cence

Brad

[dr durga]

Originally Posted by i4n

I (and a few others I know) use one of these:

http://www.actionmodelcentre.co.uk/p...od=JPD-4402900

I've used it with both Ni-Mh and LiPo and it is one of the best chargers I have used, I prefer to use it over my Much More CTX charger which cost about 3 times as much!

You'll need a power supply with it too if you haven't already got one - the one I use is http://www.modelsport.co.uk/?CallFun...n&ItemID=23410 but there are loads of others out there, just make sure it is powerful enough (better to pay a bit more now for a quality product then get a cheap one and have to buy the quality product in a few months time - I learnt this the hard way ). If you want to get both from the same place this charger is also good http://www.modelsport.co.uk/?CallFun...n&ItemID=29476, I've seen a Schumacher sponsored driver using it.

Ian

why do i need a power supply?

[mark christopher]

i have one for £20 plus postage

Simprop Intelli-Control V3 Charger
All Helis

The Inteli Control V3 goes beyond your normal Charger with lots of extra sophisticated programming. Gives fully automatic charging of NiCads and easily adjusted manually set charging of NiMH Lithium and Lead Acid batteries. Even comes with a built in cooling fan so you may charge continuously without over heating. The manual setting only requires you to set: Battery type (Nicad NiMH etc) Number of Cells Capacity Charging Current. You can also set discharge current for NiCad and NiMH to cycle the batteries and cycling can be set to be done from 1 to 99 times automatically. Pleasantly clear instructions are included. Very advanced controls.

195.00

PART#SI1036

[i4n]

Originally Posted by dr durga

why do i need a power supply?

Because they are both 12V chargers. You could use a good 12V battery (such as a leisure battery) but for ease of transport if you race inside a lot a power supply is your best bet.

The majority of the "competition" spec chargers are 12V. The ones aimed at the backyard basher etc, are the one's that are 240V.