|
|
#1
|
|||
|
|||
![]()
I need to pick up a new servo for Megan, but before I order a Savox from MB for £40, has anyone got something they don’t use any more, or is there a better alternative to the Savox, I don’t want to pay more than £40 to use car that’s only run once a fortnight indoors.
Thanks Mark |
#2
|
||||
|
||||
![]()
Have a look at these they seem ok on paper. Mr Lewis has some cheap servos that he uses and rates he mite be able to point you in a better direction
![]() http://www.hobbyking.co.uk/hobbyking...g_0_14sec.html
__________________
Nick Baker |
#3
|
|||
|
|||
![]()
I use one of the Alturn USA servo's in my Centro and have never had a problem with it and its quite quick. It's nearly £40 so its a similar price to the Savox one u mentioned. Here's a link to it http://www.modelsport.co.uk/alturn-u...roducts/359790.
I've also got the other high speed one they do which is only £18, I'll have it with me next time if u want to try it out. This is the one I mean http://www.modelsport.co.uk/alturn-u...roducts/359785 Hope this helps Mark |
#4
|
||||
|
||||
![]()
This is one the best sellers Alturn USA ĺow profile servo AAS 645 LMG £28.89. Plus postage
__________________
Top Notch Last edited by Sir Shawny500; 17-03-2015 at 06:33 PM. |
#5
|
||||
|
||||
![]()
I've used the hobbyking metal gear digi servos (can't remember whether turnigy or track star - I'm away at moment so can't check) they are -£25 and have been superb
__________________
I've got Araldite and a Swiss Army Knife - what more do I need? Yokomo YZ-2 No 4WD because nothing lives up to my original Optima. Until now maybe?... |
#6
|
||||
|
||||
![]()
might just be my bad luck, but have had 2 of the low profile and one of the ones mentioned by Tilly fail on me after a short time. probably my bad luck
|
#7
|
||||
|
||||
![]()
If I were spending my own money, I'd rather invest in a decent second hand branded item, Sanwa, Futaba etc... Usually on here they go for about £20-£25
As long as you pick your seller carefully you should be fine EDIT: http://oople.com/forums/showthread.php?t=164944 I've used Hitec before with no problems, and I know this guy is OK, if you fancy a budget option maybe send a PM and make an offer?
__________________
Last edited by Oscar; 17-03-2015 at 09:09 PM. |
![]() |
Thread Tools | |
Display Modes | |
|
|