Rear hanger faulty replacement

[empee9ine]

Xray have posted on their site the following info, there has been a lot of moaning over on RC Tech about this.

http://www.teamxray.com/teamxray/new...c0cecae03556bf

[dibble34]

I don't have setup station to check! How can you tell? Is it obvious by eye?

[Chris Larner]

Use a Vernier or callipers to measure the edge of the block to the edge of the plastic insert. It should be the same if it isn't (which for the faulty ones it is about 1mm different) then they are faulty.
Hope this helps.

[dibble34]

Thanks, been reading up and you can also take the wheels and shocks off so it sits flat and then put a ruler behind the rear pivot block and measure the distance to the wishbones each side as shown here.

http://forum.teamxray.com/viewtopic.php?f=101&t=18954

Had a quick look at mine and does look odd now, will need to measure... Not that impressed with the 2015 build quality so far.

[danDanEFC]

Is this only a xb4 2015 thing?

[dibble34]

May affect anyone using the +2 rear hangers as I understand it

[BentKa]

Originally Posted by dibble34

Thanks, been reading up and you can also take the wheels and shocks off so it sits flat and then put a ruler behind the rear pivot block and measure the distance to the wishbones each side as shown here.

http://forum.teamxray.com/viewtopic.php?f=101&t=18954

Had a quick look at mine and does look odd now, will need to measure... Not that impressed with the 2015 build quality so far.

What is wrong with the build quality of the '15 XB4 so far (except for the possibility of the rear hanger being machined incorrectly and Xray stepping up and offering free replacements) ?

Bent

[BentKa]

Info regarding the replacement program:

Following the recent customer reports of incorrect rear toe-in, we have conducted additional inspections and measurements of the previously run batches of the rear aluminum suspension holder. We found that a certain batch used an incorrect CNC program and were not produced correctly. After assembly on the car, the left and right rear toe-in are not identical. We apologize for any troubles.

A replacement suspension holder will be provided FREE of charge. As we are currently out of stock, we put them into production today, but it may still take several days until we will be ready to ship them to the distributors around the world.

To identify if you have one of these incorrect suspension holders in your kit we kindly request XB4 owners to check their rear left and right toe-in while having the same eccentric bushings installed in the suspension holders. To check the toe-in use a HUDY Set-up System #108905.

If you find a toe-in difference, please contact your distributor who will arrange you a replacement or contact us at [email protected] and please advise your address, SN and the store where the kit was purchased, we will forward you to your national distributor.

Meanwhile, until the corrected holder is available, the difference in the toe-in can be minimized by using the composite suspension holder insert with different eccentricity as needed to achieve the same toe-in.

Once again we apologize for any troubles and thank you for your ongoing support.

Bent

[dibble34]

Originally Posted by BentKa

What is wrong with the build quality of the '15 XB4 so far (except for the possibility of the rear hanger being machined incorrectly and Xray stepping up and offering free replacements) ?

Bent

I have found issues with binding in the diffs http://www.oople.com/forums/showthread.php?t=162418.