Team orion 10.1 problems

[Peakey]

Just getting everything wired up and I've got the Esc in and soldered up so just got round to programming the Esc for the first time.
I've turned it on to bind up the reciver and the red light is continuously flashing and beeping.
I've charged up the batteries so it can't be that but it just won't do anything other than beep?

What the f*** have I done wrong ?

[sime46]

They flash and beep in set up mode for the throttle stick end points when the setup button is pressed simultaneously with the on button. Is the setup button sticking? Are you pressing the setup button when you switch it on?

[Peakey]

The setup button dose t seem to be sticking you can feel and hear it clicking. It dose the same if you just turn it on and then turn it in holding the setup button.

The rx is bound as I've got steering It won't go into calibration mode. It beeps with a 1 second gap and the red light flashes.

[discothesnake]

What kind of radio gear are you using? I had a friend who had issues with an Orion speedo when he was using original DSM 1 receivers.

[Peakey]

Ko propo Helios Spektrum converted with a micro rx. But even with that unplugged it still won't go into calibration mode all it will do is flash and beep.

[spennyy2k]

Try a different motor, apparently some arnt compatible with orion speedos or maybe a sensor/ sensor wire fault