B Max champions pack roll bar mounts

[MHeadling]

Hi Guys, dont know if your kits are the same but with the champions pack you only seem to get enough hardware for 1 x Roll bar?

I mean the blue bits that grub screw onto the roll bar and the m3 grub screws and ball links that on to the wish bone.

There are no part numbers for this pack on the champions pack instruction supplement? any ideas?? are they the same as BX ones??

[DaveG28]

Originally Posted by Mark Headling

Hi Guys, dont know if your kits are the same but with the champions pack you only seem to get enough hardware for 1 x Roll bar?

I mean the blue bits that grub screw onto the roll bar and the m3 grub screws and ball links that on to the wish bone.

There are no part numbers for this pack on the champions pack instruction supplement? any ideas?? are they the same as BX ones??

Hi mate, there is a separate hopup BM412 which is "front and rear sway bar set", which I assume comes with the hardware too. If not I haven't checked but the hardware looked very similar to the Bx stuff, and for that matter Tamiya ones too!

I think the reason for only including one is that it was how Cragg ran at the Euro's, which seems true from his setup sheet in the manual! Did spot at the weekend he now runs 1.2 in the front though, but no idea what track that was meant for!

[MHeadling]

Thanks Dave! Where do you get your info? The yokomo site is a bit hard to find anything.

Not sure if this roll bar option is out to buy yet?

[spud31]

You not working dude again lololol

[MHeadling]

Of course I'm working you cheeky f##k!! If got my I phone to get on line!

You must have some spare time so see if you can find the part numbers for the bx roll bar acc's!

Do something usefull for the forum! LOL

[spud31]

try these

ZC206A Ball for ARB
ZC207 Ballcup