chassis nose

[millser]

hi guys

just wondering if there is a stronger chassis nose plate versionfor the x6 cube, i,ve broken two now sundays crash was just general one and the front end fell off

hope theres an answer

si

[Darren Boyle]

Si, whereabouts are you breaking them? We have had no issues at all and found them to be pretty bullet proof on both the X6 Cubed and the X6-S.

[Lee1972]

If you haven't already done so check that the front nose plate is bolted down properly my lad did one and it was down to the screws coming loose out of the front bulkhead.

[millser]

It is snapping where the front nose plate starts kicking up

[Darren Boyle]

Si, any breakage there is usually caused by one of two things, either the three screws going down through the back of the top plate are loose or not tight enough, which will result in extra flex on the kick up in an impact, the second can be if the two rearward screws going up into the bulkhead are over-tightened and can split the chassis holes and weakened this area. Well worth checking both of these in case this is your problem....

[millser]

Thanks will look at this when the bit arrive from yourself (Dms) hope not to break another

Cheers