Do It Your Self Low Roll Center Mod for dex210

[chet]

I know this info is on RCtech but its really hard to find info on there. I know the top Durango pro's where doing this at the big races in the U.S.

Now I know Rev. http://www.redrc.net/2013/04/rdrp-21...ension-mounts/ makes them.

But to save cash I just use the 0 anti-squat and shave 2mm on the rear suspension hanger. How much anti-squat does that give me with 2mm off?

You could just take the max off the rear hanger to give you 0 anti-squat and add shimes to change the anti-squat.

Some info would be great thanks!

[rcjunky]

Should of just sent me a FB message The math is the same with LRC as it is HRC. with the stock RR block, the 1.5* is higher then the 0* by 1mm, then the 3* by 2mm. So running the 0/3 block with the RR lowered by 2mm gives you 3*, lowered by 1mm gives you 1.5*, if you use the 0* RF block. Theoretically with the 3/3 and the RR lowered by 2mm, you can get 6* of antisqute, good by on power steering

[chet]

Thanks Andrew

A lot of guys on here like to read not reply

[j.d.roost]

Speaking of this...What are you guys typically running for squat on carpet?
Normal rules don't seem to apply when grip is this high. Need on power steering..without wheelies & traction rolling (side bite). Settled on 1.5 for now... What seems to be the best compromise for a m.motor car?

[chet]

It's my summer here in Canada so I'm running on clay now. But in the winter I run on Ozite and carpet sometimes. I use 1.5 to 2 anti squat the most

[rcjunky]

On turf I'm running 0/3. I might give 1.5/3 a whirl though, on our sweeper esque turn I get made rotation, I think a bit more rear grip will solve that, might try a bit more toe in first (currently running the 0* insert)