Fwd/reverse trouble RS pro

[Durango_Crazy_Mango]

Hi guys,

Almost at the end of my DEX410 build and I've ran into a slight problem.

I'm using the Dx3s radio and RS pro censored brushless system. The problem I have is when i first hooked it up i had to switch forward and reverse because it was backwards. After doing so forward now is noticeably slower than reverse. Can someone please help.

[Timee80]

now that youve switched forward/ reverse you need to re calibrate the speedo to the esc again like when you first set it up.

[Durango_Crazy_Mango]

Tried that also, so switched to rev on handset, start calibration on rs pro, hold for 3 secs, then go full throttle but it doesnt register it, doing my head in

[Durango_Crazy_Mango]

Its like the Tekin system is setup to go the opposite way the durango is made?? if that makes sense..

[Durango_Crazy_Mango]

Also, the LED's on the esc come from right-left under throttle, which is the opposite in the manual, which says throttle should be from left-right.

Also some have suggested swapping motor wires??

please help.

[K-Brewer]

Originally Posted by Durango_Crazy_Mango

Also, the LED's on the esc come from right-left under throttle, which is the opposite in the manual, which says throttle should be from left-right.

Also some have suggested swapping motor wires??

please help.

someone correct me if im wrong but swapping wires is for unsensored motors i thought but it does do the trick on unsensored

[adamjimny]

switch it on controller and set up using radio calibration. if motor spins in wrong direction just change motor direction in pit tune or on pc. motor wires must go A-A B-B C-C on a sensored system