Tresrey rear hanger causing lots of slop!

[Joshyjol]

So im fitting a new Tresrey RR hanger on the 210 and I notice there is loads of slop in the rear bottom wish bones after doing so.

So i have a look and notice the holes are much larger than the stock one and dont allow the hinge pins to sit snug but rather quite loose. (see pic for size difference)

Does anyone have any solutions? Do I need to be using some inserts of some sort or am I just missing a trick somewhere!

Please help, TA!

[graveltrap]

You will need some pivot balls.

http://www.team-durango.com/part-inf...artNo=TD330037

[Joshyjol]

Originally Posted by graveltrap

You will need some pivot balls.

http://www.team-durango.com/part-inf...artNo=TD330037

They kept that quiet in the advertising!

Thank you very much good sir!

[Cream]

Originally Posted by Joshyjol

They kept that quiet in the advertising!

Thank you very much good sir!

That's because the Tresrey rear hanger was out before the RTR kit. The original kit comes with the pivot balls.

[jo90]

confirm that, I run this hanger on my 210 never had an issue. I do add though a 0.5mm washer on the suspension pivot arm just to take the front to rear slop from the wishbones, it just takes it up enough that there is a little, but not 1mm worth that there was.

[mattr]

Originally Posted by jo90

confirm that, I run this hanger on my 210 never had an issue. I do add though a 0.5mm washer on the suspension pivot arm just to take the front to rear slop from the wishbones, it just takes it up enough that there is a little, but not 1mm worth that there was.

I think the instruction book actually has an extra spacer in there anyway. (possibly)