|
|
#1
|
||||
|
||||
![]()
Hi
I was wondering if anyone could help on the following I put a new ball diff in before I went to southport last week and ran my car, 4 round in my car was getting no drive Took the diff out and found the one of the thrust washers had completely eroded down and broke into little bits. Was this because the diff was too tight? I can't find out why? I've built the diff from a few videos I'd seen using the correct materials and grease Any help would be grateful Many thanks
__________________
BMRCC Member TLR 22 2.0 Speed Passion Sanwa SMC |
#2
|
||||
|
||||
![]()
To loose I reckon I remember si's bmax doing the same...............my balls damaged his rings
![]() |
#3
|
||||
|
||||
![]() Quote:
![]() |
#4
|
||||
|
||||
![]()
Like I said:
Buds Balls - the best reason ever for a geared diff!
__________________
Yz4 - Yz2 DEX210 - Cobra 4210- DEX410 RC10 Team - Manta Ray - RC10T Mini Trophy - Blizzard - Wheely King Tz4 - GT24B BMRCC Emergency back-up race controller (but only if nobody better is available) |
#5
|
|||
|
|||
![]()
Ball diffs need regular maintenance it probably hasn't been serviced enough
__________________
TLR ABSIMA Horizon Hobbies G Paint Answer RC |
#6
|
||||
|
||||
![]()
I only built a new one up 2 days before southport
__________________
BMRCC Member TLR 22 2.0 Speed Passion Sanwa SMC |
![]() |
Thread Tools | |
Display Modes | |
|
|