Drive shafts

[madmax]

Has any one else had problems with the drive shafts snapping

[fidspeed]

i believe so i ve not got my h2 yet awaiting deliverey but i have heard there a bit fragile compared to rest of car

dont know if there any options

fid

[adon30]

Stub axles yes. Drive shafts, haven't seen any problems.

[farmboy]

I had one snap. I was "landed on" by another racer and one of the drive shafts sheared off at the point where the pin goes through to hold the hex in place. This is the weakest spot I suppose.

[adon30]

Yes. That will be the stub axle that attaches to the driveshaft to for the complete cvd.
So the stub axle broke.
I'm just going to fit some different stub axles to mine, haven't got around to it yet. Fairly sure they'll fit but will post when I'm 100% sure.

[madmax]

That part I don't have a problem with mine was the dog bone end that goes into the out drive. I spoke to cml and they did replace it but just the one, I however have modified the back to take a set of Ansmann drive shafts but have to use durango wheels. The Ansmann ones are twice as thick as the Hoban ones

[sly]

I did one a few weeks ago and CML replaced it and the service and comms where very good.



I have since used a spare set of schu svr(65.5mm) driveshafts and butchered the dog end to fit in the hobao outdrive.
ran them on Easter sunday and all go so far. album of pictures of the svr driveshafts
http://s266.photobucket.com/user/sly...20schu%20drive