|
|
#1
|
||||
|
||||
![]()
Guys, I've finally got my DEX410 ready for it's maiden run today.
But the motor spins the wrong way... It's a Nosram Pearl Version 2 ESC and a Tekin Redline 6,5 motor. Can this be reversed? If so, how? All help is highly appreciated! Cheers
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
#2
|
|||
|
|||
![]()
Could it be that your diffs are in the wrong way round?
|
#3
|
||||
|
||||
![]()
Good question!
![]() (in the B44 there's a pin casted in the house to prevent this) Thx!!!
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
#4
|
|||
|
|||
![]()
Bolt heads on the diff casing should be down. There is a notch in the RR hanger to enable this, but it can be defeated (there is enough clearance, just, to wedge the diff in).
If the bolts are already down, there may be a different issue (either motor wiring, ESC set up or Tx set up) |
#5
|
||||
|
||||
![]()
Hmmm... have to check when I get home. But I'll bet I put the bolts on the upside... so that's probably the case then
![]() Cheers
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
#6
|
|||
|
|||
![]()
HAHA!
A guy at club had one in the right way and one in the wrong way! strange effect when the front wheels go forward & the rears go backward. When looking at either end of the car, The crown gear should be on the right. Its easy to say put the bolts down, But you can put the bolts in from both sides ![]() That motor/E.S.C should should work fine in stock setup |
![]() |
Thread Tools | |
Display Modes | |
|
|