speed passion reventon stock club race

[jake1*2011]

hi

i bought a reventon stock club race speedo and 8.5t motor combo a couple of days back, put it in the car and it worked fine but a bit a bit slow so i stuck a 5.5t motor on it, now it runs in reverse when i use the throttle, ive calibrated the transmitter and speedo but its still the same

it says in the spec "Max > 8.5t" does this mean nothing faster then 8.5t? if so why are they selling them with faster motors and the same speedo

how can i get this motor running the right way?

thanks

[dazzlerr6]

If I'm right the max you can go is 8.5 t so nothing lower than 8.5t. I was told by someone to always go one turn up from the limit to be on the safe side . Hope it helps abit mate .

[tcboy1983]

hi the limit on sp site says 9.5t limit so where did u buy this combo ?

[jake1*2011]

i bought it from modelsport.co.uk, i bought it as a combo and it works fine with the 8.5t motor, you can also buy them from wheelspinmodels.co.uk with a 5.5t and 8.5t motor

[tcboy1983]

so you should only run a 9.5t-21.5t on stock club race esc
the s is the same
the r goes down to 5.5t
and the pro down to 3.5t

so could of damaged something

[h0m3sy]

This is taken from the Wheelspin Models page on this esc...
Specifications:

• Supports 5.5T motors and higher with 2 cell lipo
• Adjustable items: Voltage cut off >>DRRS throttle profile setting
• Adjustable items with Optional LED Program Card (SP000007):
• Voltage cut off >>DRRS throttle profile setting
• Forward and Brake only
• % Braking ABS>>% Drag Brake>>Neutral Range>>Over Heat Protection
• On-board battery voltage & ESC temperature.
• Optional Wifi/Bluetooth connection (SP00008, SP00009)
• Official ETS Pro Stock Racing ESC (2012-2013 season)
• 2012 USVTA Approved Racing ESC (effective June 1st, 2012)

Schumacher site says nothing lower than 9.5t should be used on a 2cell lipo??????

[jake1*2011]

thats what i found, so why does the motor run in the oposite direction?

[shaun m]

have you put the motor 'A ' B ' C wires in the right way ?