|
|
#1
|
||||
|
||||
![]()
After some mixed results, I thought I'd put my X6 back to Ellis' standard set up and work forwards.
I'm worried about the front ride height though. The set up uses the standard 'arms level', but in order to set mine level, I have to have one shock nut wound down about 6 threads lower than the other. Is this normal? Or indicative or a problem elsewhere? I can't see anything amiss, but I would have thought that shock nuts in the same position would give a level ride height?? Perhaps my eyes are wonky? ![]()
__________________
For everyone I've confused: Aka Stu |
#2
|
|||
|
|||
![]()
I think this is too much different ! Have you checked the rebound of shocks ?
|
#3
|
|||
|
|||
![]()
Check the arms aren't catching on the chassis near the rear of the hinge pin and as said ^^^^^ take the springs off and check the shocks for rebound.
I race on grass and aimed for 20 to 22 mm ride height with the chassis level. I ignored whether the arms were level or not. And stand the springs next to each other and make sure they are the same length.
__________________
X6 Squared. No2 car. Novak. Savox. X6 Squared. No1 car. RS Pro, LRP. SC10 4x4 FT. Toro 120A. Tenshock. Savox. SC10. Stock spec ESC & motor. KO Propo. Powered by Nanotechnology. |
#4
|
||||
|
||||
![]()
Limiters in one of the shocks perhaps?
__________________
B-Max 2 MR
KEEP RIGHT ON BLUE IS BETTER ![]() |
#5
|
||||
|
||||
![]()
Ok then, I've just had another look over;
Springs are exactly the same size. Both arms don't rub or touch the chassis. Checked for rebound (not 100% sure I'm doing this right, but I pulled the springs off, compressed the shock shafts all the way down, then let them rise of their own accord) There is just over 0.5mm more on the left hand side shock as you look at the pic above. i.e the one that has the shock nut sitting highest when arms are level. Does that sound like enough to require such difference between shock nuts? Not sure about what the limiters in the shock are?? (I didn't build the car) Oh and thank you for all your help chaps!
__________________
For everyone I've confused: Aka Stu |
#6
|
|||
|
|||
![]()
how does the length of the shocks when fully extended compare (ideally centre of top eyelet to centre of bottom eyelet)? They should be the same - a large difference could result in the problem you are having.
|
#7
|
||||
|
||||
![]() Quote:
![]()
__________________
----Cougar 2 team----Cougar 2 works----Cougar 2000---- ----Schumacher Bosscat---- ----Traxxas TRX1----Losi XXX CR----Losi XXX BK2---- ----AE B4 ft----Xfactory X6^----DEX210 V1---- ----TLR22 3.0----TLR22 4.0----TLR22t 4.0----TLR22 5.0AC---- ----AE B6.4----
|
![]() |
Thread Tools | |
Display Modes | |
|
|