|
||
|
 |
|
||||||||||||||||||
|
|
|
#1
23-05-2008
|
||||
|
||||
Orion Motors in X5
Last night when i was trying to mesh up the pinion and spur on the x5 i noticed that the orion brushless motor was touching on the chassis thus making it hard to spin the motor to get it closer to the spur. Is this common with all brushless motors and is it safe to cut away the chassis without weakening it too much.
|
|
#3
23-05-2008
|
||||
|
||||
|
Yea if you are using the we motor plate it wont fit very well you need a std xx4 one.
A
__________________
Ashley Williams I always thought by 2013 we would have flying cars, but we have got blankets with sleeves!
|
|
#4
23-05-2008
|
||||
|
||||
|
It doesnt come out the bottom ian, i think they are just longer than other motors
|
|
#5
23-05-2008
|
||||
|
||||
|
Just dremel it and stop being gay, this isn't TC you know!
 G
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing 
|
|
#7
23-05-2008
|
||||
|
||||
|
The dremel is my friend
 Ill get the cutting disk on it when i get in
|
|
#8
23-05-2008
|
||||
|
||||
|
Quote:
 
__________________
AC S4-LRP SPHERE TC-KO2123-NOVAK 5.5L B4FT-NOSRAM EVO-KO2123-SPASHETT 10x2 http://s343.photobucket.com/albums/o...-rugby-new.gif
|
 |
| Thread Tools | |
| Display Modes | |
|
|
X-Factory
Hybrid Mode
