Team c alloy parts issue

[adey]

Hi all. I have a team tc02c with all the alloy bits and I have noticed that the front and rear hubs have play in them where the pivot pins go through. It seems the holes are slightly too large. I have new pivot pins do they are not the issue. I wondered if anybody else has had a similar issue. These parts are not cheap and I think I will end up going back to the plastic parts.

[marcel]

Shim them tight.
The play that is left is no problem .the car runs great with the aloy parts.

[adey]

I have shimmed them. If they get any tighter they won't move freely as they should. The issue as far as I can see is that the holes for the pivot pins are fractionally too large. Are they all like that ?.

[marcel]

I wil check them tomorow.
I have 5 aloy hubs.new.and.used..
Let you know if there is differents in the holes.

[john333]

Whilst I agree there is a bit of slop in the joints, I don't believe it causes any problems on the track. Mine was simply stunning indoors on carpet last night.

If all the suspension was without any play the car would be a twitchy pig of a thing to drive.

[wrighty]

As said before shim it and run it all cars are better with slop as it stops tjem being twitchy