Orion motor problem

[Duncan]

has any body had a problem with the 3mm motor mount threads on the can. my new motor has very poor threads and has stripped two of the holes.

[Adam F]

Sure its not an imperial thread screw? 4-40?

I had a rogue one in my spares box and it knackered a thread in my old motor...

[Duncan]

i have checked that it is not an imperial thread, i think it may they have used on over sized drill causing the problem. I have a novak 6.5 motor and the screw holes are perfect on that so i think i will send it back, i am curios if any body else has had a similar problem. On the orion website the can spare part is on back order ?

[RogerM]

Nope, all my Orion kit has been faultless and not heard anybody else mention this.
Send it back via the shop you bought it, sure if there is a problem you will be looked after as Orion's (Kyosho UK) customer service is brilliant

[Neil Skull]

The most likely problem is the length of your screws! check they go in far enough without touching the wind or bottoming out.

[Duncan]

i have checked all that and its all ok, its going back to JE today so they can have a look at it.