ZX-5 and Novak Brushless install

[KyoshoK]

I'd thought i share this.. as i read many post on variose forums on how to make the Novak fit with the lazer. it is a combination of all of these posts

Mine fitted very nicely here is what you do... if you want to use the Novak Esc with a fan and want to lay the receiver flat.

1. Use a futaba 9550 Servo
2. Cut the body so it is about 5mm longer than standard
3. Drill the body holes so it is 5mm lower than standard - therefore raising the body by about 5mm. (really helps if you havent painted the body yet)
4. Take off the spacers under the Novak ESC fan

Note: I used a standard Spektrum Receiver

Everything fits, body touches the motor wires a bit, but not noticable.