|
||
|
 |
|
||||||||||||||||||
|
#1
09-04-2008
|
|||
|
|||
Help With Reversing Brushless Motor
Hey guys,
So i've finished my first build (the cyclone D4) and now I've finished it, I installed my motor with a heatsink and my esc and all the other electronics and it all works but my motor goes the wrong way. How can I reset and change it to the other way? I tried using the transmitter but ofcourse when the car goes forwards it has less power and backwards it has full power. So is there a way I can do it? Could I just change the polarity or would that damage the esc? Help would be greatly appreciated Edd 
|
|
#2
09-04-2008
|
|||
|
|||
|
what make of ESC and motor do you have? It would be very strange for the motor to turn the wrong way.
__________________
4wd - X4TE 2wd - X2C (Mad Rat passed down to son!) Ansmann Racing UK RIP - MicroTech Racing Trader Feedback
|
|
#3
09-04-2008
|
||||
|
||||
|
you more than likely got two of the phase motor wires round the wrong way there by the sounds, check all you wire connections for starters.
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man!
|
|
#4
09-04-2008
|
||||
|
||||
|
A-A, B-B, C-C (from ESC to motor)
I don't think you can reverse these motors. You can for aeroplane stuff, not cars. Because most car motors are sensored. Correct me if I'm wrong... Good luck!
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
