Slipper for Blizzard

[nosequehacer]

You can expend £50 if you buy the original spares or you can make this:



All you need is:

From Blizzard, axle, pins, bearings and plastic outdrives
From X2, slipper plates and pads, spring and a spur

Use a dremmel to make the planes in both sides of the axle ( to make possible use slipper plates )
Use a 5mm bit to make the inner place of the spring

Assembly the unit. It´s possible that a you need the aid of o tronger friend, compress the spring to put the last pin is nos easy
Prove it, works fine. It´s easy to tune the original unit but this is a lot cheaper