|
#1
|
||||
|
||||
![]()
Hi all,
I am after some advice regarding setup. I have a 1.16th 2wd micro scale home-made car, which is going pretty well (See the Kitten SV thread n the schumacher section). I have a small setup issue which I am trying to resolve, involving high speed cornering, where the car seems to 'bobble' and twitch a bit off power when turning mid-corner at high speed. It does it a little bit at low speed, but is easily controllable here. I think and it feels a little like the rear roll centre needs adjusting, but I am unsure what to do. I think it needs the inner ball-stud raising to resolve this, would this be right? Thanks for any help/advice. Regards Mark
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx :: :: Paint By Turnip Paint :: |
#2
|
||||
|
||||
![]()
What is a 'bobble' boss?
Does if feel like the cornering force is making the suspension collapse under load?
__________________
SP12/RC10/XLS/JRX-2/XX/XXCR/XXCR-KE/XXX/XXXBK2/CR2/Xpro/B4/XX4/XXX4/X5/X11/DEX410/DEX210/DNX408/8ight/VW Golf GTI MK2/VW Golf TDI Wagon/Ovlov V70 D5/VW Beetle II (registered to Carrie)/Bailey Ranger/(does anyone read this bullshit?)/Creda Tumble2/HotPoint FE800/BOSCH SGS45C02GB/Dyson DC04/new patio doors & windows/freshly painted bannister rail & skirting boards, baby. |
#3
|
||||
|
||||
![]()
Yeah, kind of. It makes the whole car wiggle almost, a shimmy if you so will.
Once off power for a little longer, the whole car smooths out again. its just when fading in and out of the throttle when at high speed. ![]()
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx :: :: Paint By Turnip Paint :: |
#4
|
||||
|
||||
![]()
I'd lower it mate, matke sure the front roll centre is below that of the front , but to me that sounds like it need the inner poin lowered OR try moving to the inner hole on the uprights to increase the ratio between lower arm and toplink.
|
![]() |
Thread Tools | |
Display Modes | |
|
|