WORKSOP

[brooksy]

Can anybody advise on a setup for worksop this sunday for me?. Ill be running my x2c there for the first time so ive got no idea where to start. Do I need any extra weight up front?. Front shocks have 40wt in with kit pistons,middle hole at top and outside hole on bottom. Rear shocks have 30wt in and same top and bottom as front. Any guidance would be much appreciated.

[canon67]

Originally Posted by brooksy

Can anybody advise on a setup for worksop this sunday for me?. Ill be running my x2c there for the first time so ive got no idea where to start. Do I need any extra weight up front?. Front shocks have 40wt in with kit pistons,middle hole at top and outside hole on bottom. Rear shocks have 30wt in and same top and bottom as front. Any guidance would be much appreciated.

Use this
http://www.petitrc.com/setup/ansmann...2011031213.pdf

[Timee80]

Looks blank when I open it on my phone

[brooksy]

There is some info on there Tim but its for carpet and big bore shocks. Not much use im afraid canon67,worksop is low to medium grip and I don't have big bores on.

[MikePimlott]

I have drilled kit pistons to 2x1.4mm all round. And would start like this.

Front shocks middle hole at top inside hole at bottom 35wt oil.
Front link outside hole on tower and outside hole on hub.

Rear shocks middle hole on tower inside hole on bottom 30wt oil.
Link on tower in lower position and inside hole on hub
Medium wheelbase. May move to short on the day.

I have a lead sheet square under cells and lead sheet under servo.

[brooksy]

Cheers Mike,ill give that a try for starters on sunday and see how it goes.