|
#1
|
||||
|
||||
![]()
Hi all, my B44 should be arriving today!! cant wait!! Just thought i would setup a thread for people to share tips, setups, pros, cons, strengths, weaknesses, modifications etc
![]()
__________________
CHRIS BELL - RC10B44 |
#2
|
|||
|
|||
![]()
its not like an america forum where people set up a whole thread and ram everything into it.
this whole sub-section is devoted to AE, if you have a question, just post a new topic up in here. in answer to your question, just go with the kit setup and go heavier on the oil by 5wt or so, maybe a harder spring. depends what kind of indoor track really, will there be lots of carpet, lots of polished floor?? |
#3
|
|||
|
|||
![]()
I think it was Rich Cree that posted on the AE forum that he ran 35F and 30R at Newbury which was an indoor mixture of carpet and wood.
Silver/Green or Silver/silver seems most commen |
#6
|
||||
|
||||
![]()
is that you jimmy?? :P yer a dedicated thread would be nice.
on a crapet track i bin runnin no.1 pistons all round 40F 35R. blueF silverR. inside holes and drop it abit lower. puttin a screw in the front wishbones to stop the hinge pin comin out the back is a good idea need a few modifications though to do this and also doin some filing on the top decks so the wires arent cut to peices. |
#7
|
||||
|
||||
![]()
cheers for the prompt replies lads
![]() ![]() Chris
__________________
CHRIS BELL - RC10B44 |
#8
|
||||
|
||||
![]()
silver springs all round with 40wt front and 35wt rear is good for indoors
__________________
Custom MG-Racing Associated DMS |
#9
|
||||
|
||||
![]()
__________________
X-5^2 :: CR2 :: XXX-T MF |
![]() |
Thread Tools | |
Display Modes | |
|
|